A dishwasher that runs one cycle a day costs about $39.77 per year on an eco cycle at 0.6 kWh per cycle, about $66.28 per year on a normal cycle at 1.0 kWh, and about $99.43 per year on a heavy cycle with heated dry at 1.5 kWh. The per-cycle energy values are scenario inputs, not test results. The label on your dishwasher gives the energy per cycle for each program, and that number should replace the scenario before you rely on a total.
- What uses electricity in a dishwasher cycle
- The three cycle types used in this guide
- The same cycles in four states
- Cycle choice is the biggest lever
- Heated dry versus air dry
- Water heater and hot water
- Reading the energy label step by step
- Loading the rack for a lower-energy cycle
- Hot water and the water heater
- Installation and circuit notes
- Choosing a machine
- Maintenance that keeps energy use predictable
- Frequently asked questions
- Sources and method
What uses electricity in a dishwasher cycle
A dishwasher uses electricity in four main places. The heating element warms the wash water and the rinse water. The circulation pump moves the water through the spray arms. The drain pump removes the dirty water. The drying phase, if it uses heat, runs a second heater or a fan. The heating of water is usually the largest share of the energy in a normal cycle, which is why the water temperature and the cycle length matter so much.
A cycle’s total energy depends on its length, its temperature settings, and whether the drying phase uses heat. A short eco cycle runs at a lower temperature for a longer time, which uses less power at a time but still requires water heating. A heavy cycle adds more time and often a higher temperature, and it may add a heated dry step, so it draws more energy in total.
The three cycle types used in this guide
The guide uses three scenario inputs. Each assumes one cycle a day, or 365 cycles a year.
– Eco cycle: 0.6 kWh per cycle, a lower temperature for a longer time – Normal cycle: 1.0 kWh per cycle, a typical wash and rinse with air drying – Heavy cycle with heated dry: 1.5 kWh per cycle, a high-temperature wash with a heated dry step
Annual cost equals energy per cycle, multiplied by 365 cycles, multiplied by the rate. The rate is the U.S. average of 18.16 cents per kWh from the EIA Electric Power Monthly, Table 5.6.A, for August 2026.
| Cycle (scenario) | Cost per cycle | Annual cost (365 cycles) |
|---|---|---|
| Eco, 0.6 kWh | $0.11 | $39.77 |
| Normal, 1.0 kWh | $0.18 | $66.28 |
| Heavy with heated dry, 1.5 kWh | $0.27 | $99.43 |
The per-cycle costs are rounded from 10.9 cents, 18.2 cents, and 27.2 cents. The annual figures use the unrounded values.
The same cycles in four states
Electricity rates change the annual totals. The table below applies the EIA August 2026 state averages from Table 5.6.A to the three cycle scenarios at one cycle a day.
| Cycle (scenario) | Washington (14.63 cents) | United States (18.16 cents) | New York (28.65 cents) | California (29.75 cents) |
|---|---|---|---|---|
| Eco, 0.6 kWh | $32.04 | $39.77 | $62.74 | $65.15 |
| Normal, 1.0 kWh | $53.40 | $66.28 | $104.57 | $108.59 |
| Heavy with heated dry, 1.5 kWh | $80.10 | $99.43 | $156.86 | $162.88 |
The spread between the eco and the heavy cycle is about $60 per year at the U.S. average rate, and it is about $98 per year in California in this scenario. A household that runs the heavy cycle for every load can see a large part of the bill come from that single choice.
Cycle choice is the biggest lever
For most households, the cycle choice matters more than the machine model. A dishwasher with an eco option lets you choose the lower-energy program for everyday loads and save the heavy program for very soiled dishes. Check the cycle descriptions in your manual. Some machines list the energy per cycle on a panel or in the app, which makes the comparison easy.
Running the eco cycle on a full load is the simplest way to save. A full load uses about the same energy as a half load, so waiting until the rack is full spreads the energy over more dishes.
Heated dry versus air dry
The heated dry option adds a heating step at the end of the cycle. Air drying uses no heater, and it relies on the warm dishes and the steam to dry. Many dishes dry well with air drying, and the door can be opened slightly after the cycle to let steam escape, if the manufacturer allows it. Heated dry is useful when plastic items hold water or when the dishes need to come out dry immediately. Our dishwasher heated dry guide covers the same tradeoff in more detail.
Water heater and hot water
A dishwasher’s energy label may not include the energy used to heat water for the cycle in every case, depending on the test method. A household with an electric storage water heater pays for the hot water twice: once in the dishwasher’s internal heater, and once in the water heater that supplied the hot water. Check the water heater’s rating if you want a complete picture, and keep the hot water set point at a level that still meets your needs and your local code.
Reading the energy label step by step
The label on a dishwasher lists several numbers. Start with the energy per cycle for the standard test program, which is the most useful number for comparing machines. Next, check the water use per cycle, because hot water and cold water each carry a cost, and some households pay more for water than for electricity. Finally, look at the cycle time, because a machine that finishes faster may suit a busy household even if its energy figure is slightly higher.
Some labels show an annual energy figure based on a set number of cycles per year. That number is useful for a quick comparison, but divide it by the cycle count to get the per-cycle value, and use your own cycle count in the calculation. If the label shows several programs, pick the one you use most often for the comparison.
Loading the rack for a lower-energy cycle
A well-loaded rack helps the wash and the dry phase. Place plates and bowls facing the center of the rack so that the spray arms can reach the soiled surfaces, and keep large items clear of the spray arm’s path. Put plastic items on the top rack, away from the heating element. Avoid nesting items tightly, because water cannot clean a surface it cannot reach. A rack loaded this way often finishes cleanly on the eco cycle, which avoids the need for a heavy cycle and its extra energy.
Rinse aid helps water drain from glassware and plastics, which can reduce water spots and the need for a second run. Check the dispenser setting, because too much or too little rinse aid can affect drying. Follow the manufacturer’s dose guidance, and refill the dispenser before it runs empty so that each cycle drains properly.
Hot water and the water heater
The energy used to heat water for a dishwasher adds to the household bill beyond the dishwasher’s own energy label. The amount depends on the water temperature, the volume of water used, the water heater’s efficiency, and the incoming water temperature. A planning scenario of 0.5 kWh per cycle for the hot water supplied to the dishwasher would add about $33.14 per year at one cycle a day at the U.S. average rate, and about $54.29 per year at California’s rate. That scenario is a planning value, not a measured figure for any household. Check your water heater’s rating and your hot water use to replace it with a real figure.
If the household uses an electric storage water heater, lowering the set point slightly and insulating the hot water pipes can reduce standby losses. Keep the set point at a level that meets your needs and your local code, and check the owner’s manual before changing it.
Installation and circuit notes
A built-in dishwasher is usually on a dedicated 120 V circuit with a breaker sized for the appliance’s full load. The heating element draws more current during the wash and the dry phase than the pump alone. Check the rated amperage on the appliance label and compare it with the breaker in your panel. If the circuit also serves a garbage disposal, a microwave, or another heavy load, the combined draw can trip the breaker during a cycle.
Supply and drain connections matter too. A loose connection can leak, and a leak wastes water and can damage the cabinet. Ask a licensed installer or appliance technician to confirm the connections and the circuit during installation.
Choosing a machine
A dishwasher with an eco cycle, a sensor cycle, or a clear energy label gives you options. A sensor cycle adjusts the wash based on how soiled the load is, which can save energy when the load is light. Run one sensor cycle with a typical load and compare its time and result against the normal program before you choose one as the default. Check the cycle list in the owner’s manual before you buy, and compare the energy and water figures for the programs you use most. Keep the manual with the appliance so the cycle details are easy to find later.
Capacity matters as well. A larger dishwasher can hold more dishes per cycle, which lowers the energy per dish for a household that fills the rack. A small household that runs half loads may prefer a compact machine that suits its habits.
Maintenance that keeps energy use predictable
A clean dishwasher runs closer to its rated energy figure. Clean the filter on the schedule in the manual, check the spray arms for clogs, and wipe the door seal to keep it from trapping heat and moisture. A clogged filter reduces the wash performance, which can lead to extra cycles or a second run on the same load. That extra run uses energy the label figure does not include.
Frequently asked questions
How many cycles a day does a typical household run? That depends on the household size and the dishes used. The scenario in this guide uses one cycle a day. A larger household may run one or two cycles.
Is the eco cycle slower? Usually yes. Eco cycles run longer at lower temperatures. That is the tradeoff that saves energy.
Should I run the dishwasher at night? Only if your utility’s time-of-use plan makes off-peak hours cheaper. The energy per cycle is the same, but the rate can differ by time.
Where do I find the energy per cycle? Check the energy label, the specification sheet, or the manufacturer’s website. ENERGY STAR-certified models list their figures in the product finder.
What would this cost in your home?
Adjust the starting values to match your appliance and electricity plan.
Sources and method
Annual energy equals energy per cycle multiplied by 365 cycles per year. Cost equals that energy multiplied by the residential rate. The rate is from the EIA Electric Power Monthly, Table 5.6.A for August 2026, and the state averages come from the same table. Per-cycle energy values are scenario inputs for planning. For model-specific figures, check the energy label and the ENERGY STAR product finder. The U.S. Department of Energy Energy Saver site gives general guidance on dishwasher energy use.
For related comparisons, see our dishwasher heated dry vs. air dry guide.
Written by Seon (Site Founder & Energy Data Researcher / Home Tech Reviewer). Last checked: November 22, 2026. These are calculated estimates from scenario inputs and average tariffs, not measured results.



